For additional information, refer to . . .EG• PEG • EGH Boiler manualfor Natural or Propane gas(tankless heater application optional)PEG-30 thru -65EG
10Part Number 550-110-032/1010
1. Mount and wire controls per wiring diagram, page 10, and Figure 7.a. Attach junction box inside left jacket panel with #8-32 x ½” machine screws
Figure 8 Vent damper assembliesThe following boiler models must have damper installed:s %'THRU%'NATURALORPROPANEGASs 0%&ap
Damper installation continued4. Read and apply the harness plug warning label (shown above) so that it is visible after installa-tion.5. Plug damper
Gas valve Withoutdamper(amps)WithEffikaldamper(amps)WithJohnsondamper(amps)Honeywell VR8200 0.50 0.60 0.70Honeywell VR8300 0.70 0.80 0.90Robertshaw 72
Lighting instructions — Robertshaw 720015Part Number 550-110-032/1010Standing Pilot Boilers — Control Supplement
Lighting instructions — Honeywell VR8200/VR8300 Natural gas boilers only16Part Number 550-110-032/1010EG-30 thru 75 Series 4 and PEG-30 thru 65 Se
Lighting instructions — Honeywell VR8200/VR8300 Propane boilers only17Part Number 550-110-032/1010Standing Pilot Boilers — Control Supplement
Lighting instructions — Robertshaw 7000ERHC18Part Number 550-110-032/1010EG-30 thru 75 Series 4 and PEG-30 thru 65 Series 4
Figure 9 Manually opening vent damperIn event of vent damper failure:Effikal or Field Controls vent damperIf troubleshooting chart recommends replacin
EG-30 thru 75 Series 4 and PEG-30 thru 65 Series 4Please read this page first!>â>À`Ê`iwÌÃThe following defined terms are used throughout the
Figure 111. Checking thermocouple or thermopile open system (Figure 10):a. Use an electronic multimeter, with leads fitted with alligator clips. Set
Troubleshooting continued21Part Number 550-110-032/1010Standing Pilot Boilers — Control Supplement
Troubleshooting continued22Part Number 550-110-032/1010EG-30 thru 75 Series 4 and PEG-30 thru 65 Series 4
Troubleshooting continued23Part Number 550-110-032/1010Standing Pilot Boilers — Control Supplement
EG-30 thru 75 Series 4 and PEG-30 thru 65 Series 4 Only dampers listed below are approved for use on EG-30 thru 75 Series 4, and PEG-30 thru 55 Serie
Table of contentsHazard definitions and Note to the installer ...2Cont
4Part Number 550-110-032/1010
Figure 2EG-75 water boilers without tankless heatersFigure 11. Mount and wire controls per wiring diagram, page 4, and Figure 1.a. Attach junction b
6Part Number 550-110-032/1010
Note: Tankless heater not available on EG-75 standing pilot boilers.EG-30 thru -65 water boilers with tankless heatersControl installation continued1.
8Part Number 550-110-032/1010
1. Mount and wire controls per wiring diagram, page 8, and Figure 5.a. Attach junction box inside left jacket panel with #8-32 x ½” machine screws a
Kommentare zu diesen Handbüchern